Change name of a well in hampson russell

Note: The Time Window to Model should be larger then your seismic data if using the Shift values outside the zone option in the Wedge Model Basic tab. The windowed area is identical to the create AVO Synthetic dialog.

Note: The elastic wave algorithm if selected opens an additional tab allowing the response wavelet, wave recording, conversion modes, and additional features.Д© The Synthetic Advanced tab sets the target zone. Wavelet - is the chosen wavelet that will be used In the above chosen algorithm. Note: That the Number of Offsets sets the number of traces for each pseudo-well in the wedge model. Use this if you want to verify the processes.ДЁ The Synthetic tab sets the synthetic seismogram options: Algorithm вЂ“ is the actual algorithm that will be used to perform the wedge modeling. Output Wells - Saves all of the pseudo wells generated by the wedge modeling process. Output base survey - Creates and saves a 2D volume of the model. Recreate depth-time table - This calculates a new time-depth relationship for each pseudo well usingВ onlyВ the new sonic log. Re-compute from the zone top - Uses the time-depth curve for the original well for the section aboveВ the top of the zone and recalculates a new time-depth relationship within and below the zone by using the new sonic log. This method uses the original time-depth curve to predict the times for the pseudo wells. Shift - Preserves correlations between the log and seismic. Replace values outside the zone: The samples below the zone will be overwritten when the zone becomes thicker than the original log.Д§ Advanced Tab: Depth-time curve options: Wedge Model: Shift values outside the zone: The log values will be preserved below and above the zone of interest, so the log curves are shifted up or down. The Fix Zone Bottom of the zone is fixed but only in the Depth domain. Zone Options: The Fix Zone Top is kept level and the bottom changes. The Increment - Defines increments between the start and end parameter values.

The Zone of Interest can be formed using tops or by depths from the surface.Д¦ To set the parameters Start Value will start your wedge at the stated value and the End Value will end your wedge model at the stated value. Select the P-wave, S-wave, and Density The reservoir Interval is the zone of interest for the reservoir. This will open the parameters to generate a wedge model.ДҐ Select the Well to you would like to wedge. With the left mouse button double click the Wedge Modeling option. The wedge model feature can be generated by opening the AVO Modeling option in the processes tab. Initiate the wedge model process as indicated. (a) The wedge (b) seismic section across a linear wedge that has lower acoustic impedance than the surrounding sediments for a minimum-phase wavelet (c) amplitude versus thickness graph. The magnitude of the increase and how many amplitude maxima there are depend on the shape of the embedded wavelet. When the wedge is a quarter-wavelength (1/4) thick, the second half-cycle of the reflection from the top interferes constructively with the first half-cycle from the bottom, resulting in an increase in amplitude. The tuning effect illustrated for a wedge the material above and below it is the same, but the wedge has different acoustic impedance. This process requires a well, a wavelet, and a zone for creating the wedge.ДЈ Tuning makes two reflected signals appear as either one signal or even as no signal, this thickness therefore represents the minimum bed resolution that the wavelet can identify. In this document describes the process of creating a wedge model and viewing the tuning analysis chart.

Changes in bed thickness are introduced into the model along with changes in acoustic properties determined through rock physics modeling. Wedge Modeling is used to understand vertical (thin bed) resolution limited by seismic. It creates seismograms but lets you alter a petro-physical or fluid parameter to see the predicted changes. Wedge Modeling is part of the AVO modeling suite of tools. 1 Wedge Modeling HRS-9 Hampson-Russell SoftwareДў Wedge Modeling is part of the AVO modeling suite of tools

Change name of a well in hampson russell